install prosafe plus utility download for mac

To assign a static IP address, connect a VT100/ANSI terminal or a workstation to one of the switch’s console ports. When the computer is in this mode, the switch must also be assigned a static IP address. Use this IP value to log in to the switch. The switch is in the same subnet used by the computer NIC port when in DHCP-client mode without a DHCP server present. The switch assumes a default IP address of 169.254.100.100 and a subnet mask of 255.255.0.0. Computer in DHCP client mode with DHCP server.Ĭomputer in DHCP client mode without a DHCP server.Computer in DHCP client mode without a DHCP server.To use web management to configure your switch, use one of the following procedures, depending on how your Windows computer is set up:

For more information about CLI management, visit to download the CLI reference manual and software administration guide. It also covers how to use the CLI to determine a DHCP-assigned IP address or using ezconfig to assign a static IP address. This guide shows you how to configure your switch using the web management interface. You can manage your switch through its web management interface or by using the command-line interface (CLI) through a console port. For more information about installing an SFP module, see the hardware installation guide. Note: If purchased, SFP modules and cables are shipped separately. Use a NETGEAR AXC761 (1 m) or AXC763 (3 m) cable for a fiber port.Use a NETGEAR AXM761, AXM762, or AXM764 for a fiber port at 10 Gpbs.Use a NETGEAR AGM731F or AGM732F for a fiber port at 1 Gbps.

Use a Category 5e (Cat 5e), Category 6 (Cat 6), or Category 6a (Cat 6a) cable a for copper port at 1/2.5/5 Gbps.

Install prosafe plus utility download for mac